Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the IATS connector. |
3. |
Measure resistance between the IATS terminals 3 and 4. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Disconnect the intake air temperature sensor connector (A). |
3. |
Remove the mounting bolt (B), and then lift up to remove the sensor from the air cleaner assembly. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Front Strut Assembly Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damag ...
Valve Clearance Adjustment
Valve Clearance Inspection and Adjustment
Inspect and adjust the valve clearance when the engine is
cold (Engine coolant temperature : 20°C [68°F]) and cylinder hea ...