Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery terminal. |
2. |
Remove the fuel tank.
(Refer to Engine Control / Fuel System - "Fuel Tank") |
3. |
Disconnect the vapor tube quick-connector (A) and ventilation hose. |
4. |
Remove the canister mounting bolts, and then remove the canister (A) from the heater protect.
|
Inspection |
1. |
Check for the following items visually.
A: Canister ↔ Atmosphere
B: Canister ↔ Fuel Tank
C: Canister ↔ Intake Manifold
|
Installation |
1. |
Install in the reverse order of removal. |
Detecting sensor
The sensors are located inside of the rear bumper.
Always keep the rear bumper clean for the system to work properly. ...
Tail Gate Back Panel Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...