Kia Sedona: Cruise Control Switch Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch Repair procedures

Inspection

Measuring Resistance

1.	Disconnect the cruise control switch connector from the control switch.

Measure the resistance between terminals on the control switch when each function switch is ON (and switch is depressed).

Function switch	Terminal	Resistance (kΩ) [± 5％]
CANCEL	2 - 3	0.56
SET -	2 - 3	0.89
RES +	2 - 3	1.45
CRUISE	2 - 3	2.55
SCC	2 - 3	5.55

3.	If not within specification, replace switch.

Measuring Voltage

1.	Connect the cruise control switch connector to the control switch.

Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).

Function switch	Terminal	Voltage (V) [Vref = 5V]
CANCEL	2 - 3	1.8 ± 0.22
SET -	2 - 3	2.3 ± 0.22
RES +	2 - 3	3.0 ± 0.22
CRUISE	2 - 3	3.5 ± 0.22
SCC	2 - 3	4.2 ± 0.22

3.	If not within specification, inspect the control switch resistance.

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery terminal.

2.	Remove the air-bag module from the steering wheel. (Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")

3.	Release the remote control switch (A) after loosening the screws.

4.	Disconnect the remote control switch connector (A).

Installation

1.	Install in the reverse order of removal.

Cruise Control Switch Schematic Diagrams

Circuit Diagram ...

Ignition System

...

Other Information:

Illuminated ENGINE START/STOP button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. When all entrances ar ...

AVN keyboard Components and Components Location
Components ...

Kia Sedona: Cruise Control Switch Repair procedures

Cruise Control Switch Schematic Diagrams

Ignition System

Other Information:

Categories