Inspection |
[On vehicle inspection] |
1. |
Accelerate the engine to about 3,000 rpm 3 times or more. |
2. |
Remove the spark plug. |
3. |
Check the spark plug visually.
If the electrode is dry, the spark plug is normal.
If the electrode is wet, check the damage and electrode gap as below. |
[Component Inspection] |
1. |
Check the spark plug for any damage on its thread and insulator.
If there is damage, replace the spark plug. |
2. |
Check the electrode. Measure the insulation resistance with an ohmmeter.
If the resistance is less than the specified value, adjust the electrode gap.
|
3. |
Check the spark plug electrode gap.
If the gap is greater than the maximum, replace the spark plug.
|
Removal |
|
|
Ignition coil (Cylinder #1) [Bank 1] |
1. |
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank") |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Ignition coil (Cylinder #2) [Bank 2] |
1. |
Turn the ignition switch off and disconnect the battery negative (-) Terminal. |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Ignition coil (Cylinder #3) [Bank 1] |
1. |
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank") |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Ignition coil (Cylinder #4) [Bank 2] |
1. |
Turn the ignition switch off and disconnect the battery negative (-) Terminal. |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Ignition coil (Cylinder #5) [Bank 1] |
1. |
Remove the surge tank.
(Refer to Engine Mechanical System - "Surge Tank") |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Ignition coil (Cylinder #6) [Bank 2] |
1. |
Turn the ignition switch off and disconnect the battery negative (-) Terminal. |
2. |
Disconnect the Ignition coil connector (A). |
3. |
Remove the ignition coil after loosening the mounting bolt (B). |
4. |
Remove the spark plug. |
Immobilizer Indicator Light (Without Smart Key)
This indicator light illuminates :
...
Air bag
(1) Driver ...