Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the mode control actuator connector. |
3. |
Verify that the mode control actuator operates to the defrost mode when 12V is connected to terminal 3 and ground to terminal 7.
Verify that the mode control actuator operates to the vent mode when connected in reverse.
|
4. |
Connect the mode control actuator connector. |
5. |
Turn the ignition switch ON. |
6. |
Check the voltage between terminals 5 and 4.
It will feedback the current position of the actuator to controls. |
7. |
If the measured voltage is not within specification,
substitute with a known-good mode control actuator and check for proper
operation. |
8. |
Replace the mode control actuator if it is proved that there is a problem with it. |
Replacement |
1. |
Remove the rear heater & A/C unit.
(Refer to Rear Heater - "Rear Heater Unit") |
2. |
Disconnect the rear mode control actuator connector (A) and
then remove the rear mode control actuator (B) after loosening the
screws. |
3. |
Install in the reverse order of removal. |
Good braking practices
Check to be sure the parking brake is not engaged and the parking brake
indicator light is out before driving away.
Driving through water may get the brakes wet. They can also get wet when
...
Window opening and closing
The driver ...