Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the temperature control actuator connector. |
3. |
Verify that the actuator operates to the recirculation position when 12V is connected to terminal 3 and ground to terminal 7.
Verify that the temperature control actuator operates to the warm position when connected in reverse.
|
4. |
Connect the mode control actuator connector. |
5. |
Turn the ignition switch ON. |
6. |
Check the voltage between terminals 5 and 4.
It will feedback the current position of the actuator to controls. |
7. |
If the measured voltage is not within specification,
substitute with a known-good mode control actuator and check for proper
operation. |
8. |
Replace the mode control actuator if it is proved that there is a problem with it. |
Replacement |
1. |
Remove the rear heater & A/C unit.
(Refer to Rear Heater - "Rear Heater Unit") |
2. |
Disconnect the rear mode control actuator connector (A) and
then remove the rear mode control actuator (B) after loosening the
screws. |
3. |
Install in the reverse order of removal. |
Weight of the trailer tongue
The tongue load of any trailer is an important weight to measure because it affects
the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb
weight of the vehicle, any ...
Front Door Module Components and Components Location
Component Location
1. Front door module
...