Inspection |
1. |
Turn the ignition switch ON. |
2. |
Manually operate the control switch and measure the voltage of the blower motor. |
3. |
Operate the control switch to raise the voltage up to high speed.
Specification
|
4. |
If the measured voltage is not within specification,
substitute with a known-good field effect transistor and check for
proper operation. |
5. |
Replace the field effect transistor if it is proved that there is a problem with it. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the connector (A) and then remove the field effect transistor (B) after loosening the mounting screws. |
4. |
Install in the reverse order of removal. |
Cluster Ionizer (DATC only) Description and Operation
Description
The cluster ionizer disinfects and decomposes bad smell from
the air conditioner or air inflow. Also, it cleans the inside air of a
vehicle.
When the ignition switch is ON, the ion ...
Average Fuel Economy (2)
The average fuel economy is calculated by the total driving distance and
fuel consumption since the last average fuel economy reset.
- Fuel economy range : 0.0 ~ 99.9 MPG or L/100km
The aver ...