Inspection |
1. |
Measure the resistance between the terminals. |
2. |
If the measured resistance is not within specification, the blower resistor must be replaced (after removing the resistor). |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws. |
4. |
Install in the reverse order of removal. |
Heater Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
3.
When the engine is cool, drain the engine coolant f ...
Description and Operation
Description
The Electro Chromatic inside rear view Mirror (ECM) is
intended to dim the reflecting light in the rear view mirror. The
forward facing sensor detects the brightness of the surround ...