Kia Sedona: Troubleshooting - Heating,Ventilation And Air Conditioning - Kia Sedona YP Service ManualKia Sedona: Troubleshooting

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Heating,Ventilation And Air Conditioning / Troubleshooting

Troubleshooting
Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if the malfunction is due to lack of refrigerant, air flow or compressor.
Use the following table to find the cause of the problem. The numbers indicate the order of the likely cause of the problem. Check each part in order. If necessary, replace the corresponding parts.
After fixing the area of malfunction, check the complete system to ensure satisfactory performance.
Standard:
Symptom
Suspected Area
No blower operation
1. Blower fuse
2. Blower relay
3. Blower motor
4. Power mosfet
5. Blower speed control switch
6. Wire harness
No air temperature control
1. Engine coolant capacity
2. Heater control assembly
No compressor operation
1. Refrigerant capacity
2. A/C fuse
3. Clutch limiter
4. Compressor
5. A/C pressure transducer
6. A/C switch
7. Evaporator temperature sensor
8. Wire harness
Vented air not cold
1. Refrigerant capacity
2. Refrigerant pressure
3. Drive belt
4. Clutch limiter
5. Compressor
6. A/C pressure transducer
7. Evaporator temperature sensor
8. A/C switch
9. Heater control assembly
10. Wire harness
Insufficient cooling
1. Refrigerant capacity
2. Drive belt
3. Clutch limiter
4. Compressor
5. Condenser
6. Expansion valve
7. Evaporator
8. Refrigerant lines
9. A/C pressure transducer
10. Heater control assembly
No engine idle-up when A/C switch ON
1. Engine ECM
2. Wire harness
No air inlet control
1. Heater control assembly
No mode control
1. Heater control assembly
2. Mode actuator
No cooling fan operation
1. Cooling fan fuse
2. Fan motor
3. Engine ECM
4. Wire harness

Special Service Tools
Special Service Tools Tool (Number and name)IllustrationUse09977-3R000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly. ...

Air conditioning System
...

Other Information:

Rear window wiper blade
1. Raise the wiper arm and pull out the wiper blade assembly. 2. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place. 3. Make ...

3 Point rear center belt (for 2nd and/ 3rd center seat)
To fasten the rear center belt 1. Pull out the mini tongue from hole on the belt assembly cover (1) and then slowly pull the seat belt out from the retractor. 2. Pull out the tongue plate from ...

Categories


Copyright В© www.kisedona.com 2016-2024