1. |
Camera input
|
2. |
SVM image output
The SVM unit carries out distortion compensation and video
merging on the image from 4 cameras installed around the vehicle,
indicates steering interlocking guidelines and others, and outputs them
in analog. |
3. |
SVM switch
When the switch is ON, this is used as a control input signal that operates the front view mode. |
4. |
Ignition input
The SVM unit outputs images only when IGN2 ON. When IGN2 OFF , it is an SVM OFF state, and limits image outputting.
SVM unit uses signals inputted through IGN pin or M_CAN communication to determine whether IGN2 is ON or OFF. |
5. |
Output switch indicator lamp
SVM units output power through PWM waves from the LED located
in the SVM switch to show the user whether the switch has been pressed.
|
6. |
Input chassis CAN (C_CAN)
The SVM unit uses C_CAN to receive information about the
vehicle''s condition and to decide whether to carry out main SVM
operations. |
7. |
Multimedia CAN input/output (M_CAN)
M-CAN signal is changed to C-CAN signal by IGPM (routing
function or central gateway) and then SVM unit can use this C-CAN
signal.
M_CAN is used to communicate with IGPM to send and receive the following information:
|
Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high-pitched
warning sound from your front brakes or rear brakes. You may hear this sound come
and go or it may occur whene ...
Engine And Transaxle Assembly Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connec ...