Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover") |
3. |
Connect positive (+) and negative (-) battery cables to
terminals 3 and 2 respectively to see that the washer motor runs and
water is pumped. |
4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Rear Axle Repair procedures
Removal
1.
Remove the front wheel and tire (A) from front hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damag ...
Adjusting outside rearview mirror
Adjusting the rearview mirrors :
Press either the L (driver ...