Inspection |
Special care is needed for the following points in case of working with the non-gloss timber trimming.
|
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim") |
2. |
Remove the front door module.
(Refer to Body - "Front Door Module") |
3. |
Disconnect the connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
5. |
Check for continuity between terminals in half latching condition according to the table. |
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
2. |
Disconnect the connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
4. |
Check for continuity between terminals in half latching condition according to the table. |
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
2. |
Disconnect the connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
4. |
Check for continuity between terminals in half latching condition according to the table. |
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim") |
2. |
Remove the rear door screen. |
3. |
Disconnect the connector from the door latch.
|
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
5. |
Check for continuity between terminals in half latching condition according to the table. |
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim") |
2. |
Disconnect the connector from the tailgate latch.
[Latch]
[SCA]
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim") |
2. |
Disconnect the connector from the tailgate open switch. |
3. |
Check for continuity between the terminals and ground according to the table. |
1. |
Remove the luggage side trim.
(Refer to Body - "Luggage Side Trim") |
2. |
Check for continuity between the terminals and ground according to the table. |
1. |
Remove the hood latch assembly.
(Refer to Body - "Hood Latch Assembly") |
2. |
Disconnect the connector (A) from the hood switch. |
3. |
Check for continuity between the terminals and ground according to the table. |
Components and Components Location
Component Location
1. Head lamp (Low)2. Head lamp (High)3. Turn signal lamp, position lamp (Standard) / Turn signal lamp (HID)4. LED position lamp (Option)5. Side marker lamp6. Fog lamp7. Turn si ...
ESC OFF Switch Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the crash pa ...