Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
3. |
Remove the crash pad lower switch (A) after loosening the mounting screws. |
4. |
Remove the rheostat switch connector (A). |
5. |
Check for intensity of rheostat switch. If the light
intensity of the lamps changes smoothly without any flickering when the
rheostat is turned on, it can be assumed that the rheostat is operating
normally. |
Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram
...
Components and Components Location
Component Location Index
Engine Room
1. Ambient temperature Sensor2. Receiver-drier3. Condenser4. Compressor5. Discharge Hose6. Service Port (Low Pressure)7. Service Port (High Pressure)8. A/C P ...