Kia Sedona: Turn Signal Lamp Repair procedures - Lighting System - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Turn Signal Lamp Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Lighting System / Turn Signal Lamp Repair procedures

Removal
Door Mirror Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror (A) from the mirror holder.

   
Be careful not to damage the fixing clip

3.
Disconnect the heating connector (A) from the mirror.

4.
Remove the door mirror housing (B) after separating the mounting clips (A).

5.
Remove the door mirror turn signal lamp (A) after loosening the screw.

6.
Disconnect the connector (A) from the door mirror turn signal lamp.

Installation
Door Mirror Turn Signal Lamp
1.
Install the door mirror turn signal lamp.
2.
Install the door mirror housing.
3.
Install the door mirror.
4.
Connect the negative (-) battery terminal.
Head Lamps Repair procedures
Removal     Head lamps become very hot during use; do not touch them or attach any hardware immediately after turning them off.     • T ...

Room Lamp Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver. 3. Remove the room lamp (A) after loosening the screws. ...

Other Information:

Front Door Module Components and Components Location
Component Location 1. Front door module ...

Engine Oil and Filter Repair procedures
Inspection Engine Oil Level     Be sure that the vehicle is on level ground. 1. Warm up and stop the engine, and then wait for 5 minutes. 2. Turn the engine off an ...

Categories


Copyright В© www.kisedona.com 2016-2024