Components |
No. | Connecter A | Connecter B | Connecter C | Connecter D |
1 | - | Batt (+) | - | - |
2 | Front tilt motor (Up) | GND | - | Seat rear height sensor |
3 | Rear height motor (Up) | Batt (+) | Slide switch signal (Forward) | - |
4 | Reclining motor (Forward) | - | Reclining switch signal (Forward) | Body CAN (High) |
5 | Slide motor (Forward) | GND | Front tilt switch signal (Up) | Body CAN (Low) |
6 | - |   | Rear height switch signal (Up) | - |
7 | Front tilt motor (Down) | Slide sensor | IGN1 | |
8 | - | Reclinin sensor | Batt (+) | |
9 | - | Front tilt sensor | GND | |
10 | Rear height motor (Down) | Seat position sensor power | - | |
11 | Reclining motor (Backward) | - | - | |
12 | Slide motor (Backward) | - | - | |
13 |   | Slide switch signal (Backward) | - | |
14 | Reclining switch signal (Backward) | - | ||
15 | Front tilt switch signal (Down) | - | ||
16 | Rear height switch signal (Down) | - | ||
17 | - |   | ||
18 | - | |||
19 | - | |||
20 | - |
Evaporator Core Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater -"Heater Unit")
3.
Remove the heater unit lower case (A) after loos ...
Positive Crankcase Ventilation (PCV) Valve Repair procedures
Removal
1.
Release the PCV pad.
2.
Disconnect the vapor hose (A).
3.
Remove the PCV valve (B).
Inspection
1.
Insert a thin stick (A) into the PCV valve (B) from the threaded side to ...