1. Before closing the hood, check the following:
2. Return the support rod to its clip to prevent it from rattling.
3. Lower the hood until it is about 30 cm (1 ft.) above the closed position and let it drop. Make sure that it locks into place.
WARNING - Fire risk
Do not leave gloves, rags or any other combustible material in the engine compartment. Doing so may cause a heat-induced fire.
WARNING - Unsecured engine hood
Always double check to be sure that the hood is firmly latched before driving away. If it is not latched, the hood could fly open while the vehicle is being driven, causing a total loss of visibility, which might result in an accident.
The support rod must be inserted completely into the hole whenever you inspect the engine compartment. This will prevent the hood from falling and possibly injuring you.
Rear Door Side Weatherstrip Repair procedures
Replacement
1.
Remove the clips (C) and remove the rear door side weatherstrip (A).
Butyl tape (B) and mounting clips (C) securely seated.
2.
Install in the rev ...
Fuel Pressure Control Valve (FPCV) Troubleshooting
Signal Waveform
...