Kia Sedona: Description and Operation

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Auto Lighting Control System / Description and Operation

Description

It''s a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment''s illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.

1.	Do not place other devices on top of this device.

2.	Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.

3.	Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may vary depending on the climate, season, and surrounding environment.

4.	Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.

5.	Error may occur if light block coating that may change interior illumination is applied.

Schematic Diagrams

Circuit Diagram ...

Auto Light Sensor Repair procedures

Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor''s input (illuminat ...

Other Information:

Front light bulb replacement
Type A (1) Headlight (High) (2) Headlight (Low) (3) Turn signal light / Position light (if equipped) (4) Side marker light (5) Front fog light (if equipped) (6) Position light (if equipped) ...

Disarmed stage
The system will be disarmed when The doors (and tailgate) are unlocked with the transmitter (or smart key) or the ignition key. Pull the power sliding door out handle while the power door ON/ ...

Kia Sedona: Description and Operation

Schematic Diagrams

Auto Light Sensor Repair procedures

Other Information:

Categories