Replacement |
|
Take care not to bend or scratch the trim and panels. |
1. |
Remove the rear combination lamp cover (A) using a screwdriver or remover. |
2. |
After loosening the mounting screws, remove the rear combination lamp (A). |
3. |
Push the lock pin, then disconnet the rear combination lamp connector (A). |
4. |
Loosen the clips on rear bumper upper. |
5. |
Remove the rear mud guard (A) after loosening the screws. |
6. |
Remove the rear bumper side under cover (A) after loosening the mounting clips.
[LH]
[RH] |
7. |
Disconnect the rear bumper side.
|
8. |
Push the lock pin, then disconnect the rear bumper main connector (A). |
9. |
Remove the rear bumper cover (A). |
10. |
Install in the reverse order of removal.
|
Sunroof Motor Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the sunroof motor (A) connector.
[Fron ...
Shift Cable Repair procedures
Removal
1.
Move the shift lever to "N" range.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner)
3.
Remove the battery and battery tray.
(Refer to Eng ...