Removal |
|
|
1. |
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim") |
2. |
Loosen the nuts and remove the delta fixed glass (A).
|
3. |
Cut out the delta fixed glass sealant using the utility knife.
|
Installation |
1. |
With a putt knife, scrape the old adhesive smooth to a
thickness of about 2mm (0.08 in.) on the bonding surface around the
entire delta fixed glass flange.
|
2. |
Clean the body bonding surface with a sponge dampened in
alcohol. After cleaning, keep oil, grease and water away from the
surface. |
3. |
Apply a light coat of body primer to the outside of the body panel.
|
4. |
Peel off the tape from the delta fixed glass. |
5. |
Install the delta fixed glass (A) mounting nuts.
|
6. |
Install the front pillar trim. |
Rear Mud Guard Repair procedures
Replacement
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, an ...
Lane Departure Warning System (LDWS) Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the LDWS unit cover (A).
3.
Disconnect the LDWS unit connector (A).
4.
Remove the LDWS unit after disengaging the mou ...