Kia Optima Manuals

Kia Sedona: Rear Console Cover Repair procedures - Floor Console - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Rear Console Cover Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Remove the rear console cup mat (A).

3.
Loosen the screw and remove the cup holder case (A).

4.
Loosen the screw and remove the rear console cover (A).

5.
Press the locking pin and disconnect the connectors (A).

6.
Install in the reverse order of removal.
   
•
Make sure that the connectors are connected in properly.
•
Replace any damaged clips.
Rear Console Cover Components and Components Location
Component Location 1. Rear console cover ...

Console Armrest Components and Components Location
Component Location 1. Console armrest ...

Other Information:

Rear Door Latch Repair procedures
Replacement [Front] 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door cable (A). 3. Disconnect the rear door remote controller connector ...

Knock Sensor (KS) Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise that can cause engine damage. Two Knock Sensors (KS) are installed inside the V-valley of the cylinder bloc ...

Categories


Copyright © www.kisedona.com 2016-2024