Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Remove the rear door belt inside weatherstrip (A). |
3. |
Pull down rear door window glass by pressing the power window glass switch. |
4. |
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A). |
5. |
Completely loosen the rear door channel mounting bolt and
loosen the nuts as much as possible until they are just enough to hold
the rear door panel. |
6. |
Slightly push the rear door channel in the direction of the arrow in the illustration below. |
7. |
Remove the rear door window glass mounting hole plug (A).
|
8. |
Carefully adjust the rear door window glass (A) until you can
see the bolt, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
9. |
Install in the reverse order of removal.
|
IMS Control Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Install the driver''s door trim.
(Refer to Body - "Front Door Trim")
3.
Remove the IMS switch (A) after loosening the screws.
...
License plate light bulb replacement
1. Loosen the lens retaining screws with a phillips head screwdriver.
2. Remove the lens.
3. Remove the bulb by pulling it straight out.
4. Install a new bulb.
5. Reinstall the lens securely wit ...