Kia Optima Manuals

Kia Sedona: Tail Gate Assembly Repair procedures - Tail Gate - Body (Interior and Exterior) - Kia Sedona YP Service ManualKia Sedona: Tail Gate Assembly Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Assembly Repair procedures

Replacement
   
Wear gloves to protect hands from injury.
   
When removing and installing the tail gate, work in a group of two or more.
1.
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
Remove the tail gate side trim.
(Refer to Tail Gate - "Tail Gate Trim")
3.
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim")
4.
Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).

5.
Disconnect the connectors and tail gate wiring harness (A).
6.
Loosen the ground bolts (B).
7.
After loosening the mounting bolts, remove the tail gate assembly (C).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

8.
Remove the mounting clip (B) and then remove the tail gate lifter (A).
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

   
•
Power tail gate type
(Refer to Body Eletrical System - "PTG Spindle")
•
Remove the lifter (D) from the bracket (C) by lifting the socket clip (B) gently with a flat head screwdriver (A).

9.
Install in the reverse order of removal.
   
•
Make sure that the tail gate locks/unlocks and opens/closes properly.
•
Adjust the tail gate alignment.
•
Make sure that the connectors are connected properly.
•
Replace any damaged clips.
Tail Gate Assembly Components and Components Location
Component Location 1. Tail gate assembly ...

Tail Gate Trim Components and Components Location
Component Location 1. Tail gate trim ...

Other Information:

Exhaust Manifold Components and Components Location
Components 1. LH Exhaust manifold gasket2. LH Exhaust manifold3. LH Heat protector4. LH Exhaust manifold stay5. RH Exhaust manifold gasket6. RH Exhaust manifold7. RH Heat protector8. RH Exhaust m ...

Ignition Coil Repair procedures
Removal Ignition coil (Cylinder #1) [Bank 1] 1. Remove the surge tank. (Refer to Engine Mechanical System - "Surge Tank") 2. Disconnect the Ignition coil connector (A). 3. Remove the i ...

Categories


Copyright © www.kisedona.com 2016-2024