Removal |
1. |
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work. |
2. |
To remove the locking mechanism (A), using a flatheaded (-)
screwdriver (B), turn it counter clockwise from the emergency fastening
device (EFD) system (C). |
3. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim") |
4. |
Remove the center pillar trim.
(Refer to Body - "Center pillar trim") |
5. |
Disconnect the EFD connector (A). |
6. |
Loosen the EFD mounting bolt (B) and remove the anchor pretensioner. |
Installation |
1. |
Remove ignition key from the vehicle. |
2. |
Disconnect the negative (-) cable from battery and wait for at least thirty seconds. |
3. |
Install the EFD with a bolt.
|
4. |
Connect the EFD connector. |
5. |
Install the center pillar trim.
(Refer to Body - "Center pillar trim") |
6. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim") |
7. |
Insert the seat belt to the EFD (A).
|
8. |
Reconnect the battery negative cable. |
9. |
After installing the EFD, confirm proper system operation:
|
Power door ON/OFF button
When the power door ON/OFF button is ON (not depressed), the power sliding
door and power tailgate can be controlled with the sub control buttons on the
center pillar trim or tailgate. Also ...
Engine Room Under Cover Repair procedures
Removal
Engine Room Front Under Cover
1.
Remove the engine room front under cover (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
2.
Install in the reverse or ...