Removal |
1. |
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work. |
2. |
Remove the main crash pad.
(Refer to Body - "main crash pad assembly ")
|
3. |
Remove the passenger airbag mounting nuts (A). |
4. |
Disconnect the passenger airbag connector (A). |
5. |
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
|
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable from the battery and wait for at least 30 seconds before beginning to work. |
3. |
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
|
4. |
Install the crash pad.
(Refer to Body - "Main crash pad assembly") |
5. |
Tighten the passenger airbag mounting bolts.
|
6. |
Connect the passenger airbag harness connector to the SRS main harness connector. |
7. |
Reconnect the battery negative cable. |
8. |
After installing the passenger airbag (PAB), confirm proper system operation:
|
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1.6 mm (1/16 inch) of tread left
on the tire. Replace the tire when ...
To turn cruise control off, do one of the following
Press the CRUISE button (the CRUISE indicator light in the instrument cluster
will go off).
Turn the ignition off.
Both of these actions will cancel the cruise control operation. If you w ...