Kia Sedona: Heated Steering wheel Repair procedures - Steering wheel - Steering System - Kia Sedona YP Service ManualKia Sedona: Heated Steering wheel Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Steering System / Steering wheel / Heated Steering wheel Repair procedures

Inspection
1.
Measure the resistance of NTC and Heated pad.
–
NTC resistance : 3.42 ~ 4.18 kΩ (Standard : 25°C)
–
Heated pad resistance : 1.5 ~ 1.9 Ω (Standard : 19 ~ 21°C)
2.
Measure the temperature.
–
The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute.
–
The temperature of wheel surface grip must keep 38°C after 25 minutes.
Heated Steering wheel Schematic Diagrams
System Circuit Diagram ...

Restraint
...

Other Information:

Rear Pillar Trim Repair procedures
Replacement [Rear Pillar Trim]     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, ...

Knock Sensor (KS) Repair procedures
Removal [Bank 1] 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") ...

Categories


Copyright © www.kisedona.com 2016-2024