Removal |
Take care not to scratch the crash pad and related parts. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing") |
3. |
Remove the BCM & Receiver unit (A) after loosening the nuts.
(Refer to Body Electrical System - "BCM (Body Control Module)") |
4. |
Replace the receiver, and then perform the learning process using a diagnostic instrument (GDS). |
Diagnostic Procedure Using a Diagnostic Instrument |
1. |
Connect the diagnostic instrument to the self-diagnostic
connector (16-pin) beneath the crash pad on the side of driver''s seat,
and then turn on the ignition to activate the diagnostic instrument. |
2. |
In the GDS Vehicle Type Selection menu, select "Vehicle Type" and "TPMS" System, and then opt for "OK." |
Front Door Inside Handle Repair procedures
Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door inside handle cage (A).
3.
Loosen the screw and remove the IMS switch.
4. ...
One time driving information mode
Type B, C
This display shows trip distance (1), average fuel economy (2) and the vehicle
can be driven with the remaining fuel (3).
This information is displayed for a few seconds when you turn ...