Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (5) and signal terminal (17).
|
Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Anti-Pinch Strip Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tail gate trim.
(Refer to Body - "Tail Gate Trim")
3.
Disconnect the anti-pinch strip sensor connector (A).
4.
R ...
Disc Brakes and Pads Repair procedures
Inspection
Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage.
Front Brake
Front brake disc thickness check
1.
Check the brake pads for wear and fad ...