Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (10) and signal terminal (7).
|
Replacement |
If a solenoid valve of VFS type needs to be replaced, the
valve body assembly should be replaced and the oil pressure should be
adjusted. If the solenoid valve is replaced individually, it is not
possible to adjust the oil pressure without additional equipment, and if
the oil pressure adjustment procedure is not performed, a shift shock
or delay may occur. |
1. |
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
Specifications
Specifications
ItemSpecificationFront/Rear parking assist system control unitRated voltageDC 12VOperation range40~120 cm (15.7~47.2 in)Operation voltageDC 9V~16VOperation currentMax. 300 mAOperat ...
Seat belt warning (for front passenger
Type A
Type B
The front passenger's seat belt warning light will activate to the following
table when the ignition switch is in "ON" position.
*1 The seat belt warning light w ...