Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between power terminal (10) and signal terminal (2).
|
Removal |
1. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover") |
2. |
Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.
|
3. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
4. |
Remove the wiring bracket (A) and the air breather hose (B).
|
5. |
Lift the vehicle after loosening valve body cover upper bolts. |
6. |
Remove the valve body cover (A) by loosening bolts.
|
7. |
Remove the solenoid valve harness (A) and oil temperature sensor (B) after removing the bolts.
|
8. |
Remove solenoid valve support bracket (A).
|
9. |
Remove the torque converter control solenoid valve (B) after loosening the bolt (A).
|
Installation |
1. |
Install in the reverse order of removal.
|
Specifications
Tightening Torque
ItemN.mkgf.mlb-ftPassenger airbag(PAB)7.8 ~ 11.80.8 ~ 1.25.8 ~ 8.7Curtain airbag (CAB)Bolt7.8 ~ 10.80.8 ~ 1.25.8 ~ 8.7Nut3.9 ~ 5.90.4 ~ 0.62.9 ~ 4.3Seat Belt Anchor Bolt39.2 ~ 5 ...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...