Kia Sedona: Output Speed Sensor Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

3.	Disconnect the solenoid valve connector (A).

Measure the resistance between power terminal (3) and signal terminal (4).

Specification : Approx. 0.88 MΩ

Removal

1.	Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")

2.	Disconnect the input & output speed sensor connector (A).

Remove the input & output speed sensor (B) after loosening the bolts.

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation

Install in the reverse order of removal.

•	Refill the automatic transaxle with fluid. (Refer to Hydraulic System - "Fluid")

•	• Confirm that there is no fluid leakage on connections after repairing.

Output Speed Sensor Schematic Diagrams

Circuit Diagram ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Specification Item SpecificationControl typeN/L (Normal Low)Control pressure kpa (kgf/cm², psi)"9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54)"Current value (mA)50 ~ 850Coil resistance(Ω)5.1 ± 0.3 ...

Other Information:

Components and Components Location
Components 1. Automatic transaxle assembly2. Automatic transaxle support bracket3. Torque convertor4. Inhibitor switch5. Solenoid valve connector6. Manual control lever7. ATF cooler pipe8. Valve ...

Troubleshooting
TPMS Inspection method Inspection Find the inspection number by referring to the table above. The following content is irrelevant of the inspection procedure. 1. ...

Kia Sedona: Output Speed Sensor Repair procedures

Output Speed Sensor Schematic Diagrams

Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications

Other Information:

Categories