Inspection |
1. |
Turn ignition switch OFF. |
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery") |
3. |
Disconnect the solenoid valve connector (A). |
4. |
Measure the resistance between + terminal (9) and - terminal (13). |
5. |
Check that the resistance is within the specification.
|
Removal |
The oil temperature sensor is integrated with the solenoid
valve main connector and can not be disassembled. The oil temperature
sensor should be replaced with the solenoid valve main connector. |
1. |
Move the shift lever to "N" range. |
2. |
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body") |
3. |
Disconnect the input & output speed sensor connector (A). |
4. |
Loosen the solenoid valve harness bolts (B).
|
5. |
Disconnect the solenoid valve connector (A). |
6. |
Remove the clip (A) and then remove the connector by pressing it downward.
|
Installation |
1. |
Install in the reverse order of removal. |
|
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots,etc.) may interfere with your ability to use the brake and
acceler ...
Rear Seat Assembly Repair procedures
Replacement
[Second row seat assembly]
[7Seat/8Seat]
1.
Loosen the second row seat front mounting bolts (A) after opening the cap (B).
2.
Pull up the seat by pulling the stand-up lever.
...