When removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, injury may be caused by leakage of
high pressure fuel. For this reason, do not attempt any repairing
immediately after engine stops.
[Bank 1]
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
2.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
3.
Disconnect the injector & rail pressure sensor extension connector (A).
4.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
5.
Remove the high pressure fuel pipe.
(Remove the Fuel Delivery System - "Fuel Line")
6.
Remove the mounting bolts (A), and then remove the delivery pipe & injector assembly [Bank 2] from the engine.
Do not use already used injector fixing clip again.
•
Install the component to the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
•
Apply engine oil to the injector O-ring.
•
Do not use already used injector O-ring again.
•
Do not use already used bolt again.
•
When insert the injector, be careful not to damage the injector tip.
•
When installing the high pressure fuel pipe and cross over
pipe, apply the specified tightening torques with the special service
tool (A). [SST No. 09314-3V100]
Removal
1.
Open the fuel filler door and then remove the filler-neck mounting bolts (A).
Filler-neck assembly mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
2.
Left the ...
Inspection
Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.Removal
High pressure fuel pipe (High pressure fuel pipe ↔ Delivery pipe)
...
Other Information:
Power sliding door and power tailgate
On the overhead console
On the center pillar trim
On the tailgate
(1) Left power sliding door control button
(2) Right power sliding door control button
(3) Power tailgate control button*
...
General Information
Basic Service Symbols
There are five primary symbols used to complement
illustrations. These symbols indicate the part to apply such materials
during service.
SymbolMeaningDo not reuse the p ...