Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve. |
5. |
Remove the canister close valve (C). |
Installation |
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting. |
1. |
Install in the reverse order of removal. |
Rheostat Components and Components Location
Components
...
How to reset the power sliding door and power tailgate
If the battery has been discharged or disconnected, the related fuse has been
replaced or disconnected, and the power sliding door or power tailgate doesn't work
properly, the power sliding ...