Removal |
1. |
Disconnect the battery negative cable, and wait for at least 30 seconds before beginning to work. |
2. |
Left side - Remove the seat belt lower anchor cover (A).
After loosening the mounting bolt, remove the seat belt lower anchor
(B).
Right side - To remove the locking mechanism (A), using a
flatheaded (-) screwdriver (B), turn it counter clockwise from the
emergency fastening device (EFD) system (C). |
3. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim") |
4. |
Remove the center pillar trim
(Refer to Body - "Center pillar trim") |
5. |
Remove the upper anchor bolt. |
6. |
Loosen the seat belt pretensioner mounting bolts (A,B) and remove the seat belt pretensioner. |
7. |
Disconnect the seat belt pretensioner connector (C). |
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable and wait for at least thirty seconds. |
3. |
Connect the seat belt pretensioner (BPT) connector (C). |
4. |
Install the seat belt pretensioner with bolts (A, B).
|
5. |
Install the upper anchor bolts.
|
6. |
Install the center pillar trim
(Refer to Body - "Center pillar trim") |
7. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim") |
8. |
Left side - Install the lower anchor bolts.
Right side - Insert the seat belt to the Emergency fastening device (A).
|
9. |
Reconnect the battery negative cable. |
10. |
After installing the seat belt pretensioner, confirm proper system operation:
|
84,000 km (52,500 miles) or 42 months
❑ Rotate tire
❑ Inspect battery condition
❑ Inspect air cleaner filter
❑ Inspect vacuum hose
❑ Inspect power steering fluid (if equipped)
❑ Inspect power ...
Occupant Detection System(ODS)
Type A
Type B
Your vehicle is equipped with an occupant detection system in the front passenger's
seat.
The occupant detection system is designed to detect the presence of a properly-seat ...