Diagnosis With GDS |
1. |
BSD system defects can be quickly diagnosed by the GDS. GDS
quickly operates actuator to monitor input/output values and to
self-diagnose. |
2. |
Connect the cable of GDS to the data link connector on driver side crash pad lower panel, and turn the power on GDS. |
3. |
Select the vehicle model and then BSD system. |
4. |
Select "Current Data", if you want to check current data of BSD system. |
5. |
If you want to check each module operation forcefully, select "Actuation test". |
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering column upper and lower shrouds ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil
...