Kia Sedona: Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body (Interior and Exterior) / Front Door / Repair procedures

Adjustment

Glass Adjustment

Check the glass run channel for damage or deterioration, and replace if necessary.

1.	Remove the front door trim. (Refer to Front Door - "Front Door Trim")

2.	Remove the front door window glass mounting hole plug (A).

3.	After loosening the mounting bolts, carefully move the front door window glass (A) left and right to adjust the gap until the glass mounting bolts are visible.

4.	Check that the glass moves smoothly.

Door Striker Adjustment

Make sure that the door latches securely without slamming it. If necessary, adjust the striker (A): The striker nuts are fixed. The striker can be fine adjusted up and down, or in and out.

Loosen the screws (B) just enough for the striker to move.

Tightening torque :

(B) : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)

2.	Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment.

3.	Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.

Door Position Adjustment

After installing the door, check for a flush fit with the body, then check for equal gaps between the front, rear, and bottom, door edges and the body. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.

1.	Check that the door and body edges are parallel.

2.	Place the vehicle on a firm, level surface when adjusting the doors.

Adjust at the hinges (A) :

•	Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.

•	Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.

•	Place a shop towel on the jack to prevent damage to the door when adjusting the door.

Tightening torque :

(B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

4.	Grease the pivot portions of the hinges indicated.

5.	Check for water leaks.

Components and Components Location

Components 1. Front door inside handle cover2. Front door body side weatherstrip3. Front door side weatherstrip4. Front door quadrant inner cover5. Front door pull cap6. Front door belt inside w ...

Front Door Trim Components and Components Location

Component Location 1. Front door trim ...

Other Information:

Front Bumper Cover Components and Components Location
Component Location 1. Front bumper cover ...

Audio Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia upper panel. (Refer to Body - "Center Fascia Panel") 3. Remove the audio head unit (A) after loosening ...

Kia Sedona: Repair procedures

Components and Components Location

Front Door Trim Components and Components Location

Other Information:

Categories