Component Replacement After Deployment |
Before performing any SRS repairs, use the GDS to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing related
DTCs. |
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inpsect the clock spring for heat damage.
If any damage is found, replace the clock spring.
|
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) for the deployed side(s) |
– |
SRS wiring harnesses
|
– |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Rear Seat Cushion Cover Repair procedures
Replacement
[Second row seat assembly]
[7Seat/8Seat]
When reclining or returning the second-row seat in upright position, secure enough space in front and back of t ...
Exhaust Manifold Repair procedures
Removal and Installation
[LH Exhaust Manifold]
1.
Disconnect the battery negative terminal.
2.
Remove the engine cover.
(Refer to Engine and Transaxle Assembly - "Engine Cover")
3.
Remov ...