Kia Sedona: Rear Wiper Motor Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Removal

Set up to automatically operate wipers of rear window glass when reverse gear shift is engaged while the wipers of windshield glass are in operation in ''Instrument Panel - User Setting Menu (USM).

1.	Detach the rear wiper cap (A).

2.	Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B).

3.	Remove the rear wiper cap & pad (A).

4.	Remove the tailgate trim after opening the tailgate. (Refer to Body - "Tailgate Trim")

5.	Disconnect the rear wiper motor connector (A) and then remove the rear wiper motor (B) after loosening bolts.

Installation

Install the rear wiper motor assembly.

Tightening torque bolt :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

2.	Install the tailgate trim.

Install the rear wiper arm cap after tightening the nut.

Tightening torque Nut :

8.8 ~ 12.7 N.m (0.9 ~ 1.3 kgf.m, 6.5 ~ 9.4 lbf.ft)

4.	Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.

Inspection

Rear Wiper Motor

1.	Remove the connector from the rear wiper motor.

2.	Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.

Check that the motor operates normally. Replace the motor if it operates abnormally.

No.	Description
1	Battery (+)
2	Parking
3	Switch
4	Ground

Automatic Stop Operation Check

1.	Operate the motor at low speed using the stalk control.

2.	Stop the motor operation anywhere except at the off position by disconnecting terminal 2.

3.	Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.

4.	Check that the motor stops running at the off position.

Components and Components Location

Component Location 1. Head cap2. Rear wiper arm nut3. Rear wiper arm & blade4. Cap & pad assembly5. Rear wiper motor assembly6.Rear wiper motor bolt ...

Rear Washer Switch Repair procedures

Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not in normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear ...

Other Information:

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired positi ...

Seat belt warning (for front passenger
Type A Type B The front passenger's seat belt warning light will activate to the following table when the ignition switch is in "ON" position. *1 The seat belt warning light w ...

Kia Sedona: Rear Wiper Motor Repair procedures

Components and Components Location

Rear Washer Switch Repair procedures

Other Information:

Categories