Kia Sedona: Rear Temperature Control Actuator Description and Operation
The heater unit consists of mode control actuator and temperature control actuator.
Located in the heater unit, the temperature control actuator regulates the temperature in the following procedure.
Signal from control unit adjusts the position of the
temperature door by operating the temperature switch. Then the
temperature will be regulated by the hot/cold air ratio decided by the
position of the temperature door.
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the actuator operates to the recirculation position when 12V is connect ...
Other Information:
Repair procedures
Component Replacement After Deployment
Before performing any SRS repairs, use the GDS to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing relat ...
Rearview camera
The rearview camera will activate with the ignition switch ON and the shift lever
in the R (Reverse) position
This system is a supplemental system that shows behind the vehicle through the
re ...