Replacement |
[7Seat/8Seat] |
1. |
Loosen the second row seat front mounting bolts (A) after opening the cap (B). |
2. |
Pull up the seat by pulling the stand-up lever. |
3. |
Loosen the second row seat rear mounting bolts (A) after opening the cap (B). |
4. |
Remove the second row seat assembly (A). |
5. |
Install in the reverse order of removal. |
[Leg support type] |
1. |
Loosen the seat front mounting bolts (A) after opening the cap (B).
[LH] |
2. |
Pull up the seat by pulling the stand-up lever. |
3. |
Loosen the seat rear mounting bolts (A) after opening the cap (B). |
4. |
Remove the second row seat assembly (A). |
5. |
Install in the reverse order of removal. |
1. |
Tumble the second row center seat assembly (B) after pulling the lever (A). |
2. |
Remove the second row center seat assembly (B) after pulling the lever (A) in the direction of arrow. |
3. |
Install in the reverse order of removal. |
1. |
Using a screwdriver or remover, remove the third row seat leg cover (A). |
2. |
Remove the third row seat assembly (A) after loosening the bolts and nuts. |
3. |
Install in the reverse order of removal. |
Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the speci ...
Knock Sensor (KS) Repair procedures
Removal
[Bank 1]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
2.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
...