Inspection |
1. |
The windshield deicer switch inputs can be checked using the GDS. |
2. |
To check the input value of windshield deicer switch, select option "Body Control Module". |
3. |
Select option "Current Data". |
4. |
To perform functional test on SJB outputs, select "Actuation Test". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater & A/C control unit.
(Refer to Heating, Ventilation, Air Conditioning - "Heater & A/C Control Unit (DATC))
(Refer to Heating, Ventilation, Air Conditioning - "Heater & A/C Control Unit (Manual)) |
Installation |
1. |
Install the heater & A/C control unit.
(Refer to Heating, Ventilation, Air Conditioning - "Heater & A/C Control Unit (DATC))
(Refer to Heating, Ventilation, Air Conditioning - "Heater & A/C Control Unit (Manual)) |
2. |
Connect the negative (-) battery terminal. |
Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 30 km/h (18.6 mph), the sys ...
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
AcceleratorPositionOut ...