Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using a screwdriver or remover, remove the rear combination lamp cover (A). |
3. |
Remove the rear combination lamp (A) after loosening the mounting screws. |
4. |
Disconnect the rear combination lamp connector (A). |
1. |
Remove the rear combination lamp. |
2. |
Remove the turn signal lamp bulb (B) by turning the socket (A) counterclockwise. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear combination lamp cover (A). |
3. |
Disconnect the rear combination lamp connector (A). |
4. |
Remove the rear combination lamp (A) after loosening the mounting nuts. |
1. |
Remove the rear combination lamp cover. |
2. |
Remove the stop/tail lamp (B) by turning the socket (A) counterclockwise. |
Installation |
1. |
Connect the rear combination lamp connector. |
2. |
Install the rear combination lamp. |
3. |
Install the rear combination lamp cover. |
4. |
Connect the negative (-) battery terminal. |
1. |
Install the rear combination lamp. |
2. |
Connect the rear combination lamp connector. |
3. |
Install the rear combination lamp cover. |
4. |
Connect the negative (-) battery terminal. |
Power Sliding Door (PSD) Switch Repair procedures
Inspection
Overhead Console Door Switch Inspection
1.
When inspecting, use the inspection equipment to check for
input/output values of Overhead console door switch. If there''s any
malfunct ...
Rear window wiper and washer switch
The rear window wiper and washer switch is located at the end of the wiper and
washer switch lever. Turn the switch to the desired position to operate the rear
wiper and washer.
HI : Continuous ...