Kia Sedona: Rear Alignment Repair procedures
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Suspension System / Rear Suspension System / Rear Alignment Repair procedures
| Rear wheel alignment |
When using a commercially available computerized wheel
alignment equipment to inspect the rear wheel alignment, always position
the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension
system is in normal operating condition and that the tires are inflated
to the specified pressure. |
Toe
B - A > 0: Toe in (+)
B - A ＜ 0: Toe out (-) |
Toe adjustment
| 1. |
Loosen the nut holding the assist arm cam bolt (A). |
| 2. |
Adjust rear toe by turning the rear assist arm cam bolt (A)
clockwise or counter clockwise. Toe adjustment should be made by turning
the right and left cam bolt by the same amount.
|
| 3. |
When completing the toe adjustment, tighten the nut to specified torque.
|
Camber
Camber is pre-set at the factory, so it does not need to be
adjusted. If the camber is not within the standard value, replace or
repair the damaged parts and then inspect again.
Camber : -1.0° ± 0.5° |
Rear Sub Frame Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage ...
Tires/Wheels
...
Other Information:
Blind Spot Detection Indicator Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror (A) from the mirror holder.
Be careful not to damage the fixing clips (A).
3.
...
Parking Assist Sensor Repair procedures
Removal
Front/Rear PAS Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front/rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Co ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright © www.kisedona.com 2016-2024