Inspection |
1. |
Connect the GDS to the Data Link Connector (DLC). |
2. |
Measure the output voltage of the RPS at idle and various engine speed.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal. |
2. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line"). |
3. |
Remove the intake manifold.
(Refer to Engine Mechanical System - “Intake Manifold”) |
4. |
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe. |
Installation |
|
1. |
Install in the reverse order of removal.
|
Description and Operation
Description
MDPS Development
By comparing the electric power steering system with the conventional hydraulic pressure system (HPS)
1.
Effect of reducing the number and weight of parts by deleti ...
Battery Sensor Description and Operation
Description
Vehicles have many control units that use more electricity.
These units control their own system based on information from various
sensors. It is important to provide a stable power ...