Kia Sedona: Rail Pressure Sensor (RPS) Description and Operation
Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Description and Operation
| Description |
Rail Pressure Sensor (RPS), installed on the delivery pipe,
measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Rail Pressure Sensor (RPS) Specifications
Specification
Pressure [MPa (kgf/cmВІ, psi)]Output Voltage (V) [Ref=5V]0 (0, 0)0.510 (102, 1450)2.520 (204, 2900)4.5
...
Rail Pressure Sensor (RPS) Schematic Diagrams
Circuit Diagram
...
Other Information:
168,000 km (105,000 miles) or 84 months
❑ Rotate tire
❑ Inspect battery condition
❑ Inspect air cleaner filter
❑ Inspect vacuum hose
❑ Inspect air conditioning refrigerant
❑ Inspect brake hoses ...
Rear Door Side Weatherstrip Repair procedures
Replacement
1.
Remove the clips (C) and remove the rear door side weatherstrip (A).
Butyl tape (B) and mounting clips (C) securely seated.
2.
Install in the rev ...
Categories
- Home
- First Generation
- Second Generation
- Third generation
- Kia Sedona YP 2014-2024 Owners Manual
- Kia Sedona YP 2014-2024 Service Manual
Copyright В© www.kisedona.com 2016-2024