Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door quadrant inner cover (A). |
3. |
Disconnect the power door mirror connector from the harness. |
4. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
[Actuator]
[Mirror Control (LH/RT)]
[Puddle Lamp]
[BSD Indicator]
[Mirror Heater]
[Side repeater Lamp]
[Folding Mirror] |
1. |
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
|
2. |
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester. |
3. |
Select the ''Body Control Module (BCM)'' to check the driver seat or assistant door module (DDM/ADM). |
4. |
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked. |
5. |
If you wish to check the power door lock operation by force, select "Actuation test". |
Alternator Specifications
Specification
ItemSpecificationRated voltage13.5V , 150ASpeed in use1,500 ~ 18,000rpmVoltage regulatorIC Regulator built in typeDefault regulated voltage (V) [COM terminal]14.0 ~ 15.5 (-35°C)14. ...
Fuel Filter Repair procedures
Replacement
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the fuel sender connector (A) and fuel pump connector (B).
3.
Remove the cushion pipe ...