Kia Optima Manuals

Kia Sedona: Power Door Lock Switch Repair procedures - Power Door Locks - Body Electrical System - Kia Sedona YP Service ManualKia Sedona: Power Door Lock Switch Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch Repair procedures

Inspection
Diagnosis With GDS
1.
The body electrical system can be quickly diagnosed for faulty parts using vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information:
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point
2.
Select the ''Car model'' and the system to be checked in order to check the vehicle with the tester.
3.
Select the ''Body Control Module (BCM)'' to check the driver seat or assistant door module (DDM/ADM).
4.
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the driver seat or assistant door module(DDM/ADM) can be checked.

5.
If you wish to check the power door lock operation by force, select "Actuation test".
Removal
   
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
Driver Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Loosen the front door armrest (A) mounting screws.

4.
Using a screwdriver or remover, separate the mounting clips and then remove the driver door module panel (A).

5.
Loosen the mounting screws and then remove the driver door module(DDM) (A) after separating the mounting clips.

   
Be careful not to damage the mounting clips.

Installation
1.
Install the driver door module (DDM).
2.
Install the driver door module panel.
3.
Install the front door armrest mounting screws.
4.
Install the front door trim.
5.
Connect the negative (-) battery terminal.
Power Door Lock Actuators Repair procedures
Inspection     Special care is needed for the following points in case of working with the non-gloss timber trimming. • Wrap a protective tape around tools used ...

Power Door Mirrors
...

Other Information:

Electronic Power Steering (EPS) Warning Light
This warning light illuminates : Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction wit ...

SS-A Solenoid Valve(ON/OFF) Description and Operation
Description • SS-A solenoid valve is ON/OFF type. • When TCM supplies variable current to solenoid valve, speed range is changed by operating the solenoid valve. SS-A Soleno ...

Categories


Copyright © www.kisedona.com 2016-2024