Removal |
1. |
Disconnect the battery negative cable and wait for at least 30 seconds before beginning to work. |
2. |
Remove the main crash pad.
(Refer to Body - "main crash pad assembly ")
|
3. |
Remove the passenger airbag mounting nuts (A). |
4. |
Disconnect the passenger airbag connector (A). |
5. |
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
|
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable from the battery and wait for at least 30 seconds before beginning to work. |
3. |
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).
|
4. |
Install the crash pad.
(Refer to Body - "Main crash pad assembly") |
5. |
Tighten the passenger airbag mounting bolts.
|
6. |
Connect the passenger airbag harness connector to the SRS main harness connector. |
7. |
Reconnect the battery negative cable. |
8. |
After installing the passenger airbag (PAB), confirm proper system operation:
|
Hands free mic Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp.
(Refer to Body Electrical - "Overhead Console Lamp")
3.
Remove the hands free mic (A) from ...
Comfort mode
The steering wheel becomes lighter. The comfort mode is usually used when driving
in the city or when parking the vehicle.
For your safety, if you press the steering mode button while operatin ...