Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel") |
3. |
Remove the junction box.
(Refer to Body Electrical System - "Relay Box(Passenger Compartment")) |
4. |
Disconnect the parking brake switch connector. |
5. |
Remove the parking brake cable mounting nuts (A). |
6. |
Remove the parking brake pedal mounting bolts (A) and nut (B). |
7. |
Remove the parking brake cable the fixing clip(A, B), and then remove the parking brake pedal. |
Installation |
1. |
Install the holding clip (A, B) after fixing the parking brake cable. |
2. |
Install the parking brake pedal, and then install the parking brake pedal mounting bolts (A) and nut (B). |
3. |
Adjust the parking brake pedal stroke by turning the adjusting nut (A).
|
4. |
Reconnect the parking brake switch connector. |
5. |
Install the junction box.
(Refer to Body Electrical System - "Relay Box(Passenger Compartment")) |
6. |
Install the crash pad lower panel.
(Refer to Body - "Crash pad lower panel") |
Adjustment |
1. |
Operate the parking brake pedal through a full stroke over 3 times for setting the parking cables. |
2. |
Adjust the adjusting nut (A) for parking brake pedal stroke of 8-9 notches when operating effort is 294 N (30kgf, 66lbf).
|
Front Disc Brake Components and Components Location
Components
1. Guide rod bolt2. Bleed screw3. Caliper carrier4. Caliper body5. Inner pad shim6. Brake pad7. Pad retainer
...
Lane changing
A vehicle which moves into your lane from an adjacent lane cannot be recognized
by the sensor until it is in the sensor's detection range.
The sensor may not detect immediately when a ve ...