Kia Sedona: Master Cylinder Repair procedures - Brake System - Brake System - Kia Sedona YP Service ManualKia Sedona: Master Cylinder Repair procedures

Third generation YP (2014-2024) / Kia Sedona YP Service Manual / Brake System / Brake System / Master Cylinder Repair procedures

Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly (A).

3.
Disconnect the brake fluid level switch connector (B), and remove the reservoir cap.

4.
Remove the brake fluid from the master cylinder reservoir with a syringe.
   
•
Do not spill brake fluid on the vehicle as it may damage the paint. If brake fluid comes in contact with the paint, wash off immediately with water.
5.
Disconnect the brake tube (C) from the master cylinder by loosening the tube flare nut.

Tightening torque:
18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

6.
Remove the master cylinder (B) from the brake booster after loosening the mounting nuts (A).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Installation
1.
Install in the reverse order of removal.
2.
After installation, bleed the brake system.
(Refer to Brake system - "Brake system Bleeding")
Master Cylinder Components and Components Location
Components 1. Reservoir cap2. Reservoir3. Grommet4. Master cylinder5. O-ring ...

Brake Line Components and Components Location
Components ...

Other Information:

Specifications
Specifications ItemsSpecificationsRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-104°F ~ 185°F (-40°C ~ 85°C)Dark currentRKE : 2mASMK : 1.5mAKeyless : 1.5mA ...

Description and Operation
Description The Electro Chromatic inside rear view Mirror (ECM) is intended to dim the reflecting light in the rear view mirror. The forward facing sensor detects the brightness of the surround ...

Categories


Copyright © www.kisedona.com 2016-2024